Radius is the state-of-the-art circular wall formwork systems for all round walls from a radius of 250 cm upwards. It is compatible with the Mammut 350 wall formwork system and the panels are connected with each other using the same MEVA assembly lock. Radius has a sturdy 6 mm steel facing for a superior concrete finish. Its benefits are the very quick, easy assembly and the easy selection of any radius. Box outs are aligned using high-performance magnets. Radius is predestined for architectural concrete requirements.
Concrete load capacity 60 kN/m²
Easy setting of the desired radius using integrated spindles, accurate to the millimetre, spindles with covering
Height adjustment via integrated screws (optional)
Tieing with DW 20 tie rods, load transfer with walers
High-performance magnets used to attach professional wooden or plastic box-outs
Integrated lifting unit
Circular formwork system for all radii from 250 cm
Panels joined and aligned using the M-assembly lock compatible with the Mammut 350 wall formwork System
Panel heights of 150, 300 and 350 cm correspond to panel sizes in the Mammut 350 System
Steel sheet as forming face with durable, high-tech coating
Easy ganging to form large forming Units
Simple, accurate compensation up to 16 cm with filler timber and Uni clamps.
The use of high-performance magnets to attach box-outs on steel facing has a long tradition on construction sites all over the world. It has proved to be reliable and quick. The magnets used in the Radius circular formwork system hold firm even with high concrete pressure and very fast pours. The same is true of strips.
for fast, safe lifting of the formwork using a standard crane hook.
Simple height adjustment via spindle to even out unneven ground.
Push-pull props and walkway brackets are attached to the welded-in DW nuts with a flange screw. The offset typical with circular formwork is handled with the Radius tie-off clamp RS using a DW tie rod and alignment rails.