Project: Flood relief channel for water reservoir at Pont-et-Massène, France
Builder: Navigable waterways authorities
Contractor: Maïa Sonnier & Maïa Fondations
Engineering: MEVA Formwork Systems, Seon, Switzerland
The water reservoir on the Armançon river in central France west of Dijon is used for swimming, sports, fishing, water supply and water level regulation. Built from 1878 to 1882, the old barrage is being completely renovated and equipped with a new highpeformance flood relief channel that is poured with MEVA rental formwork.
Heavy-duty MEVA systems for large scale applications
The new flood relief channel descends like a stair from top to bottom, it is quite steep and equipped with high perimeter walls ensuring that much water can flow off very fast without causing flooding and damage. Where possible, the wall formwork is placed on the horizontal part of a step and the wall section extending along that step poured in one cycle. With wall sections up to 15 m long, the 3.50 m high panels of the heavy-duty Mammut 350 system are the ideal choice to pour them fast and efficiently using largesize panel gangs composed of panels height-extended several times and of up to 4 or 5 height-extended units side by side. Such large panel gangs are crane-lifted from cycle to cycle without requiring time-consuming disassembly and re-assembly, thus saving much labour. Much additional time is saved thanks to the system’s 100 kN/ m² fresh concrete capacity that allows for fast pours with an unlimited rate of pouring for the first 4 meters. The free-standing perimeter wall on the valley side is poured with doublesided wall formwork in combination with the modular SecuritBasic safety system that comes with intergrated safety – platforms, ladder access and railings are part of the system and do no require any job-site solutions. The wall sections of the perimeter wall on the hillside are poured with doublesided wall formwork where the distance of the wall to the rock allows for such a solution. All other sections are poured single-sided using STB 450 support frames and Mammut 350 panels.
In order to support the heavy loads, the legs of the STB 450 support frames must be attached to anchors cast in the base slab. But what do if there is no base slab? MEVA and Maïa Sonnier engineers developed the solution in joint cooperation: The front legs are attached to anchors previously cast in the perimeter wall and the rear legs to a horizontal steel girder. One end of this girder is attached to the adjoing base slab on the samel level, the other end to a vertical steel girder that is firmly attached to the adjoinng base slab below.
“This is a unique solution for a problem no one else solved and one of the reasons why we are using MEVA formwork on this site”, confirms the site manager Clément Jouanneau. “I am impressed with the superior quality of the concrete finish, with the performance of the Mammut 350 and the stability of the systems that handle the tough job on this site without problems.”
Referencen for Projets in Commercial & Residential Construction, Architectural Construction, High-Rise Construction and Civil Engineering Construction
The focus of MEVA's first collaboration with Austrian company GLS was nature conservation and the construction of two fish passes on the River Traun.
The underground flood control basin in Bern‘s city centre was built over 40 years ago.
Gravity walls to the tunnel entrance, up to 14 m high,poured using a single-sided adaptation of the MGC guided climbing system and Mammut 350 wall panels.